The steps below follow the order of the work for this decor project.
Bekob rejoice — Jaime is back! She’s here today for Deck The Walls, and she’ll be sharing her tip-top building skills here regularly, too! look at this straightforward-peasy way to use up some wood scraps while adding some color and personality to a room with these wood pennant banner:
How to Make a Wood Bunting
Hello Bekob readers! Jaime here from That’s My Letter to share a wood bunting project today. I build, paint and sew everything sharing all my projects and the step by step instructions on my blog but I’m also a periodic contributor here at Cassity’s place and I’m happy to be back joining everyone and sharing handmade projects and inspiration.
Let’s make this wood bunting today and I’ll show you how using ½” plywood scraps.
This makes a great gift for a new baby or a child’s birthday, or make it in colors to coordinate with your party decorations and you have inexpensive wall decor that will last a lot longer than any paper banner.
Supplies:
– 1/2″ wood scraps
– cotton fabric scraps (background and lettering)
– brass grommets
– jute rope
– miter saw, measuring tape, pencil
– rotary cutter, ruler, self healing mat
– spray adhesive
– iron, ironing pad, scissors
– double sided fusible interfacing (heat ‘n’ bond)
– lightbox
– drill and drill bits
* Follow all safety precautions when using power tools.*
Step 1: Cut 1/2″ plywood scraps into triangle shapes. It will go fast if you have one board at 7 3/4″ wide then set your miter saw at the desired angle and make cuts flipping the board over every cut in order to get a triangle shape.
Step 2: Stain the triangle pieces and let dry. Cut fabric pieces 1/4″ smaller than wood triangle on sides and 1/2″ smaller at top.
Step 3: Apply spray adhesive to wrong side of fabric triangles.
Step 4: Press sticky fabric onto wood triangle and smooth.
Step 5: To make lettering prepare a piece of scrap fabric with heat’n’bond double sided fusible interfacing. Iron one side of fusible (the side without the paper) onto the wrong side of the fabric.
Step 6: Print out desired letters. I use Ariel font bold.
Step 7: Place print out letter face side down onto light box.
Step 8: Place right side of fabric on top of letter and trace onto paper backing.
Step 9: Cut out letter. Be sure to keep paper backing on until you are ready to iron letter in place. For another look at how to make iron on fabric letters see my post here.
Step 10: Peel paper backing off letter and iron in place onto background fabric. Predrill holes for grommets at top corners. (Use a drill bit about same size or slightly smaller than grommet.)
Step 11: You want grommet to be snug. Place grommet over hole and hammer down in place. 
Once all grommets are in place thread the jute string through the top and your wood bunting is now ready to hang!
Hope you enjoyed this scrap wood project and think twice next time about throwing out scraps!
Looking for more handmade projects using wood, fabric and paint? For a quick glimpse at my work look at this handmade outdoor rolling console. Or for a sewing project I made zippered pouches from an apron here. And I recently put together this handmade Wonka themed birthday party for those crafty folks out there.
———————————————–
Thanks for sharing, Jaime — this is well fitted for a kid’s room or party!
Enjoying #DeckTheWalls?
There’s still so much more to come, including this modest-cost-friendly license plate art:
Make sure you don’t miss it! Subscribe by RSS or email (daily, weekly, or monthly).
