Read the sequence from the top before cutting, painting, or moving pieces.
Hey! This is Sandra for Sawdust and Paper Scraps (now Sawdust Girl) here to show you one of my recent projects! I bought about 5 old lamps when I was shopping for items to make my Halloween Candelabra walkthrough. I only used 2 for that So I had a couple left to make these Spooky Bad Boys. Remember I said I had a project in mind to use up the other half of the PVC and threaded rod? Well, this was what I had in mind… only I didn’t actually end up using either the PVC or threaded rod so now I have to come up with another project altogether! Darn! For this project I used : 2 lamp purchased at Goodwill (about $3 each) 3 plastic skulls purchased at the dollar store ($1 each) 1 can of satin black spray paint (the low-cost stuff from Lowes- $1) Oh yeah! You know I alway have about 5 projects going on at once!1. Take your lamps apart and paint the pieces
2. Drill holes in your Skulls. 3. Mess around with configuring all the parts until you find a design your happy with. I put these together about 6 different ways before I decided on this particular arrangement. I used the lamps original rods, which are threaded both ends, so I had to play with adding and taking away pieces to make them just the right height. 4. Paint the SKULLS! 5. Distress. 6. Put them back together. You could drill a hole in the tops that are deep enough for the nut to fit down inside so the top is flush. I didn’t want to take the time so I just screwed it right on top. My candles are a little concave and it doesn’t matter a bit. If you’re candles are flat on the bottom, just melt a little wax away to make room. And that’s it folks. Total cost- $10No, that does not include the studded skull on the left, I just threw him in for decoration.
But I still think it’s quite a bargain!
