Handmade Arbor Swing: Lattice Purlins & Beam Supports (Part 2)

The steps below follow the order of the work for this porch and patio project.

We’re sharing step by step as we build a Handmade arbor swing in a striking backyard! This is Step 10: installing lattice purlins on top of rafters for an arbor or pergola, and adding the second beam supports.

Follow along on YouTube, Instagram, TikTok, or Facebook to see each step, or subscribe here to get our new blog post emails

Watch the full Handmade Arbor Swing Step-By-Step video playlist here.

Installing Lattice Purlins & Beam Supports

But wait… didn’t I already show you how to install arbor rafters / purlins and also how to install the beam supports?

Yup, I sure did. Today’s video is showing how I finished up the lattice purlins and how I added the second set of beam supports. Not a lot new, but it’s coming together nicely!

I specifically waited to add the second set of beam supports to make it easier to install the rafters. Leveling and attaching the beams across 2 points is much easier than across 4 points.

Handmade Arbor Swing Installing Purlins And Second Beam Supports Bekob

As you can see in the video, after attaching the purlins / rafters to the beams, I installed the second set of beams just like the first set, with 4 lag screws in pre-drilled holes.

straightforward peasy — next I’ll show you how I installed those striking curved wood brackets!

Stay tuned and subscribe to see how I stain the cedar arbor, add the swing hangers, and add the paverstone patio – right up until the finished project reveal!